您好,欢迎来到贵州AG8工程机械有限公司官网!

贵阳装载机

新闻分类

产品分类

联系AG8

公司名称:贵阳AG8工程机械有限公司


联系人:杨经理


手  机:15186981858

            

网  址:www.bastard-divine.com


邮箱:1721318949@qq.com


地  址:贵州省贵阳市观山湖区金华镇金华小学后面


贵阳直喷装载机浅谈装载机装卸操作说明

您的当前位置: 贵州装载机出租 >> 新闻中心 >> 行业新闻

贵阳直喷装载机浅谈装载机装卸操作说明

发布日期:2018-02-05 作者:贵阳直喷装载机 点击:

贵阳直喷装载机浅谈装载机装卸操作说明

Description of loader loading and unloading operation of Guiyang direct injection loader


贵阳直喷装载机

贵阳直喷装载机认为装载机在装卸操作过程中,除散粮以外,不准用高速档取货,不准边行驶边起升铲斗。

Guiyang direct injection loader thinks the loader is not allowed to use high speed gear in addition to grain during loading and unloading operation.

1、装载机的发动机水温及润滑油温度达到规定值时方可进行全负荷作业,当水温或者油温超过363K(90度)时应停车,查找原因,待水温低于363K(90度)时方可作业,否则会损坏发动机。

1, when the loader's engine temperature and lube oil temperature reach the specified value, it can carry out full load operation. When the water temperature or oil temperature exceeds 363K (90 degrees), it should stop to find the cause. When the water temperature is below 363K (90 degrees), it can work, otherwise it will damage the engine.

2、装载机安全操作时要求禁止在前后车体形成角度时铲装货物。取货前,应使前后车体形成直线,对正并靠近货堆,同时使铲斗平行接触地面,然后取货。

2. When the loader is safe to operate, it is required to forbid the loading of the cargo when the front and back body is formed. Before taking the goods, the front and back bodies should be formed in a straight line, right and close to the cargo heap, and the bucket is exposed to the ground parallel to the ground, and then the cargo is taken.

3、装载机在装卸操作过程中,除散粮以外,不准用高速档取货,不准边行驶边起升铲斗。

3, the loader in the handling process, in addition to the scattered grain, not allowed to use high speed gear, not allowed to drive edge lift shovel.

4、装载机铲斗铲装货物应均衡,不准铲斗偏重装载货物。装载机是用来进行装载及短途运输散装物料的车辆,禁止用铲斗进行挖掘作业。

4. The loader shovel loading and shovel goods should be balanced, and the bucket is not allowed to load the cargo. The loader is a vehicle used for loading and short haul bulk materials, and it is prohibited to use a bucket to excavate.

5、装载机驾驶员离车前,应将铲斗放到地面,禁止在铲斗悬空时驾驶员离车。起升的铲斗下面严禁站人或进行检修作业。若必须在铲斗起升时检修车辆,应对铲斗采取支撑措施,并保证牢固可靠。

5, when the loader driver leaves the car, the bucket should be put on the ground to prevent the driver from leaving when the bucket is suspended in the air. From the following liter bucket or prohibited to stand maintenance operations. If the vehicle must be overhauled when the bucket is lifted up, the supporting measures should be taken to the bucket and ensure it is firm and reliable.

6、禁止用铲斗举升人员从事高处作业,禁止在码头岸边直接铲装船上的物料。

6, it is forbidden to use shovel lifting personnel to work in high places and to forbid direct shoveling of materials on the shore of the dock.

7、装载机在架空管线下面作业,铲斗起升时应注意不要碰到上方的障碍物,在高压输电线路下面作业时,铲斗还应与输电线保持足够的安全距离。

7, loaders work under the overhead pipeline. When lifting the hoist, we should pay attention not to touch the obstacles above. When working under the high voltage transmission line, the bucket should also maintain enough safety distance with the transmission line.

8、在为载重汽车倾卸物料,装载机铲斗前翻时不得刮碰车辆,卸载动作要缓和。在卸车作业时,应注意铲斗不要刮碰车厢。在推运或刮平作业中,应随时观察运行情况,发现车辆前进受阻,应审慎操作,不得强行前进。

In 8, as the truck dump loader bucket before not scraped vehicle unloading action to ease. When unloading the car, pay attention to the bucket do not touch the car. In the operation of pushing or leveling, the operation should be observed at any time. It is found that the vehicle is obstructed and should be carefully operated and not forcibly moved forward.

9、装载机停车后应将换向操纵杆放到中央位置,将前后车体安全联接杆安装好。

9. After the loader parking, the reversing joystick should be placed in the central position, and the front and back car body safety connecting rod should be installed.


本文网址:http://www.bastard-divine.com/news/376.html

关键词:贵阳直喷装载机,直喷装载机,贵阳直喷装载机公司

最近浏览:

  • 在线客服
  • 联系电话
    13885175275
  • 在线留言
  • 在线咨询
    欢迎给AG8留言
    请在此输入留言内容,AG8会尽快与您联系。
    姓名
    联系人
    电话
    座机/手机号码
    邮箱
    邮箱
    地址
    地址